SMART AUTOMATICBATTERY CHARGEROWNER’S MANUAL & WARRANTY INFORMATION12 VOLT 2/10/25 AMP WITH 75 AMP ENGINE STARTALTERNATOR VOLTAGE CHECK AND BATTER
TROUBLESHOOTING - FAULT LED LITThe following conditions may cause the FAULT CODES to be displayed:• Poor connection to battery (or frame).• Charging t
PERCENT OF CHARGE75% 50% 25% 0%2 AMPS 6.5 12 NR NR10 AMPS 1.8 3.0 4.5 625 AMPS 0.8 1.4 2 2.7* Not recommendedThe times shown in the chart above are ap
WARRANTYThis limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities ofVector Manufacturing
PERSONAL PRECAUTIONS AND SAFETY1. Another person should be close enough to come to your aid when you work near a lead-acid battery.2. Fresh water and
PREPARING TO CHARGE1. Determine voltage of battery by referring to car owner's manual.2. If necessary, remove battery from vehicle to char
FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED OUTSIDE VEHICLE. A SPARK NEARBATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY
INTRODUCTION AND FEATURESThank you for selecting the Vector Model VEC1095A 2/10/25 AMP 12 Volt Smart Battery Charger, with Alternator Voltage Checkand
FIGURE 3A (FRONT VIEW)WARNINGS: THERE ARE NO USER-SERVICEABLE PARTS IN THIS CHARGER. DO NOT OPEN THE UNIT! IT MUSTBE RETURNED TO POWER ON BOARD FOR P
Below the Digital Display are series of six LEDS that light on the following conditions:WET - Lights when battery type selector is on WET battery type
CHARGING THE BATTERY1. Charger displays circulating pattern when battery and AC power are connected properly. Select battery type and press 2/10/25AMP
NOTE: BATTERY VOLTAGE button is disabled in Alternator Check mode.ALTERNATOR VOLTAGE CHECK: will not work in normal charge mode it will only work in t
Comments to this Manuals