Vector JUMP-START SYSTEM Owner's Manual download pdf (Page 9)

CAUTION:

•

If engine fails to start, leave ignition key turned off and disconnect the negative

(-) clamp first, then the positive (+) clamp. Try again later – the engine may be

flooded.

• Recharge jump-start system after each use.

WARNING:

• Always disconnect the engine or frame jumper clamp first; followed by the

battery jumper clamp

• Never allow red and black clamps to touch each other or another common

metal conductor; this could cause damage to the unit and/or create

sparking/explosion hazard

• There is a risk of explosive gases being released when batteries are charged

or discharged. Failure to follow instructions may cause property damage,

explosive hazard, and/or personal injury

• Always use protective eyewear when using this product: contact with battery

acid may cause blindness and/or severe burns

• Keep out of children’s reach

• ALWAYS store battery clamps on clamp tabs when not in use. Never touch

battery clamps together, this can cause dangerous sparks, power arcing

and/or explosion

FIRST AID:

• SKIN: If battery acid comes in contact with skin, rinse immediately with

water, then wash thoroughly with soap and water. If redness, pain, or

irritation occurs, seek immediate medical attention

• EYES: If battery acid comes in contact with eyes, flush eyes immediately for

a minimum of 15 minutes and SEEK IMMEDIATE MEDICAL ATTENTION

3. CHARGING/RECHARGING

For maximum battery life, we recommend the VECTOR

system be kept fully

charged at all times. If the battery is allowed to remain in a discharged state,

battery life will be shortened.

NOTE: Recharging battery after each use will prolong battery life; frequent

discharges between recharges will reduce battery life

IMPORTANT:

• MAKE SURE ALL SWITCHES ARE TURNED OFF DURING RECHARGING

• Charge unit for full 48 hours using AC method, prior to first use

• Recharge unit fully after each use

• Recharge unit once a month when not in use

VEC022 Manual_Final_073106.qxp 7/31/06 6:36 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Vector JUMP-START SYSTEM Owner's Manual Page 9