Vector V08 User Manual download pdf (Page 37)

INSTALLATION DIRECTIVEMAY 2006

V08 ENT M75

M11

M12

14. PREPARING THE ENGINE FOR FIRST

START-UP

15. TESTS BEFORE THE FIRST START-UP

1. Drain the residual 30/M protective oil from the sump.

2. Pour into the lubricating loop only lubricating oil of the

type and in the quantities set out in the Refilling Table.

3. Drain the CFB protective liquid from the fuel loop,

completing the operations as indicated under item 3. of

Chapter 19.

4. Remove the caps and/or seals from the engine intake,

exhaust, aeration and venting ports, restoring normal

conditions of use. Connect the inlet of the turbocharger

to the air filter.

5. Connect the fuel loops to the boat tank, completing

the operations set out in item 4. of Chapter 19. During

filling operations, connect the pipe returning fuel to the

tank to a collecting container, to prevent residues of CFB

protective liquid from ending up into the boat tank.

6. Verify and refill engine coolant as prescribed.

7. Remove from the engine the labels with the inscription

“ENGINE WITHOUT OIL”.

Although they are extremely important, “common sense”

checks such as the exposure of sensitive parts (plastics, wire

harness, electronic units, etc. ...) to heat, and those that for

years have characterized the quality of the work performed

in the yard, are not mentioned herein.

Tests of the proper operation of the engine and the com-

ponents of the electronic control system may be performed

rapidly and with the utmost reliability using specific diagnostic

tools, available from IVECO MOTORS Technical Assistance

Centres.

Fuel tank suction

Verify the fuel suction at the maximum allowed longitudinal

and transverse inclination, with the residual quantity of fuel

considered “RESERVE”, such as to cause the reserve indica-

tor light to be permanently lighted.

Throttle lever position sensor

In the positions of minimum and maximum travel, verify the

correlation between the position of the throttle control

valve on the bridge and the position of the sensor rod.

Instruments and control panel

Verify the efficiency of all light indicators, as described in the

related Chapters.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Comments to this Manuals

No comments

Vector V08 User Manual Page 37

Comments to this Manuals