Vector V08 User Manual download pdf (Page 58)

INSTALLATION DIRECTIVE MAY 2006

V08 ENT M75

M11

M12

1. Oil discharge control.

Lubricating oil exhaust operations are simplified by the

presence of an electrical control system connected to the JG

connector of the interface wiring harness. Manual control for

exhaust operations is positioned on the front panel unit. For

safety reasons, control is enabled only with the key switch in

the “OFF” position.

1. Not used - 2. Not used.

The module (on request) is connected to the JG1 connector

of the interface wiring harness.

The task of pre-lubricating the engine’s internal components

is managed and controlled by the electronic circuit of the

module when the key switch is placed in “ON” position.

#(!2'%

$)3#(!2'%

/&&#(!2'%

%6$)3#(!2'%

04_037_C

LUBRICATING OIL TRANSFER MODULE PRE-LUBRICATION MODULE

Figure 1 Figure 2

04_036_C

1 2 ... 53 54 55 56 57 58 59 60

No comments

Vector V08 User Manual Page 58