Vector V08 User Manual download pdf (Page 44)

INSTALLATION DIRECTIVE MAY 2006

V08 ENT M75

M11

M12

19. PREPARING THE ENGINE FOR LONG IDLE PERIODS

To prevent oxidation to the internal parts of the engine and

to some components of the injection system, if idle periods

exceeding two months are expected, the engine needs to

be prepared with six-month periodicity, proceeding as

follows:

1. Drain the lubricating oil from the sump, after heating the

engine.

2. Pour 30/M protective oil (alternatively, oil conforming to

MIL 2160B Type 2 specifications) into the engine to the

“minimum” level marked on the dipstick.

Start the engine and let it run for about 5 minutes.

3. Drain the fuel from the injection line and from the filters,

taking care to prevent the fuel from coming in contact

with the alternator’s belt.

4. Connect the fuel line to a tank containing CFB protec

tive liquid (ISO 4113) and assist the inflow of the liquid

by pressurizing the line and turning the engine over for

about 2 minutes, after excluding the operation of the

injection system. The required operation may be carried

out by directly polarizing the terminal 50 of the electric

starter motor with positive voltage 24 V, using a conduc-

tor prepared for the occasion.

5. Nebulize 30/M protective oil at the rate of about 100 g

(10 g per litre of displacement) in both turbochargers,

while the engine is turning over as described above.

6. Close with suitable stoppers or seal with adhesive tape

all engine intake, exhaust, aeration and venting ports.

7. Drain the residual 30/M protective oil from the sump; it

may be re-used for 2 more engine preparation opera-

tions.

8. Apply tags with the inscription “ENGINE WITHOUT

OIL” on the engine and onboard panel.

9. Drain the coolant, if it has not been mixed with anti-

freeze and corrosion inhibiting agents, affixing tags to

indicate that the operation has been carried out.

If external parts of the engine are to be protected, spray

protective liquid OVER 19 AR onto unpainted metal parts,

such as flywheel, pulleys and others; avoid spraying belts, con-

nector cables and electrical equipment.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 59 60

Comments to this Manuals

No comments

Vector V08 User Manual Page 44

Comments to this Manuals